Using tado° heating products
By Jurian1 author28 articles
- How do I test the heating and hot water on my Wireless Receiver?
- What are the best settings for my tado° heating devices during the summer months?
- How can I restart my tado° devices?
- How can I reset the pairing of my Smart Thermostat or Wireless Temperature Sensor?
- How does tado° control multiroom heating systems with more than one heat source?
- How does tado° control a multi-zone radiator heating system?
- How does tado° control different heating systems?
- How does tado° control radiator heating systems with a central thermostat?
- How does tado° control underfloor heating systems?
- How does tado° control radiator heating systems without a central thermostat?
- How does tado° control multiroom heating setups with a combination of radiators and water-based underfloor heating?
- How does tado° control Heating Zones? How can I change the Zone Controller of a room?
- My Smart Thermostat is not shown as a Zone Controller. What can I do?
- Where is the best place to install my Smart Thermostat or Wireless Temperature Sensor?
- Do I need Wi-Fi to use tado°?
- What happens when the batteries of my tado° devices run out?
- What type of batteries should I use in my tado° devices? How do I replace them?
- How do I perform the upgrade from my current Bridge to the HomeKit-enabled Internet Bridge?
- Why does tado° keep heating even after reaching the target temperature?
- Do I need Smart Radiator Thermostats in the room in which I already have a Smart Thermostat or Wireless Temperature Sensor installed?
- Do I need a Wireless Temperature Sensor in a room that already has Smart Radiator Thermostats installed?
- Do I need Smart Radiator Thermostats for all my radiators?
- What do the symbols on the Smart Thermostat or Wireless Temperature Sensor user interface mean?
- What do the symbols on the Smart Radiator Thermostat user interface mean?
- What do the symbols on the Wireless Receiver mean?
- What do the LEDs and blinking states on the Wireless Receiver mean?
- What do the blinking states on the Extension Kit mean?
- How do I activate the pairing mode of the Internet Bridge?