To restart the Internet Bridge, press and hold the pairing button until all the LEDs on the device turn off (for about 10 seconds). Then release the button and your device will restart automatically.

If you have the earlier version of the Bridge without the pairing button, you can restart it by simply disconnecting it from the power supply for 30 seconds. When you plug it back in, your device will restart automatically.

To restart the Smart Thermostat or the Wireless Temperature Sensor, press the button on the bottom right of the device until the display turns off (for about 10 seconds). Then release the button and your device will restart automatically.

To restart the Smart Radiator Thermostat, remove the batteries from the device and wait 10 seconds before putting them back, then close the battery compartment. Then wait 1 minute before you remount the device. This ensures the device will calibrate successfully. Your device will then restart automatically.

To restart the Wireless Receiver, press the main button on top of the device (for about 10 seconds) until the LEDs on the front turn off. Then, release the button and your device will restart automatically.

To restart the Extension Kit, press the button on top of the device until the LED on the front turns off (for about 10 seconds). Then release the button and your device will restart automatically.

To restart the Smart AC Control, disconnect it from the power supply for about 10 seconds. When you plug it back in, the device will automatically restart.