If you can’t or don’t want to fix your Wireless Temperature Sensor to the wall, you can use the tado° Stand to position your device on a table or other surface in the room.

You can also use the Stand with the Smart AC Control.

This will allow for more flexibility when positioning your devices, to enhance their functions.

Fitting your device onto the Stand

Wireless Temperature Sensor

To fit the Wireless Temperature Sensor to the Stand please do the following:

  1. Remove the backplate of the Wireless Temperature Sensor.

  2. Position the backplate on the Stand, so that the top screw holes on both pieces are aligned.

  3. Use the screws provided with the Stand to fix the backplate to the Stand as shown, then

  4. clip the Wireless Temperature Sensor back onto the backplate.

Smart AC Control

To fit the Smart AC Control to the Stand please do the following:

  1. Unplug the power cable from the device, then

  2. feed the cable through the slot in the Stand and plug the cable back into the Smart AC Control, as shown.

  3. Position the device on the Stand, and

  4. pull the cable up into the narrower section of the slot to secure the device in place.

For best results, position the Smart AC Control near a power socket, with a clear line of sight to the IR transmitter of the AC unit.

More information:

Where is the best place to install my Smart Thermostat or Wireless Temperature Sensor?

Did this answer your question?